![](/assets/cup/zero.png)
![](https://s3.amazonaws.com/cup-images/patriciaplatt/large/cup539521_1416.jpg)
![Price Promise - You will not find this product cheaper elsewhere!](/assets/cup/bestprice.png)
Baby Boy Aperture Card Topper and Insert
This is an aperture type of topper and insert. Put the aperture onto your card front using either foam pads or doublesided tape and cut out the centre section.
You might cut the aperture section first and use that as a template to cut your card front.
Make sure to centre them. And with the insert, place this on the centre of the inside of your card. There are various sentiments for different occasions and a blank one for your own words. The fonts used are Monterey BTand Freehand591 BT.
The size of the squares are roughly 135mm/and a little less than 5 1/2 inches.
![Baby Boy Gatefold Card Kit](https://www.craftsuprint.com/theme/common/images/zero.png)
![New Baby Boy Insert 7x7](https://www.craftsuprint.com/theme/common/images/zero.png)
![](https://www.craftsuprint.com/theme/cup/images/multi2.png)
![Baby Boy Box](https://www.craftsuprint.com/theme/common/images/zero.png)
![](https://www.craftsuprint.com/theme/cup/images/multi2.png)
![Goldstar Available](https://www.craftsuprint.com/theme/cup/images/goldstar_sm.png)
Photographs from the Community
![](https://s3.amazonaws.com/finished-cards/michelle-chivers/photo731066.jpg)
![Goldstar](https://www.craftsuprint.com/assets/cup/goldstar.png)
![](https://www.craftsuprint.com/theme/common/images/zero.png)
![](https://s3.amazonaws.com/finished-cards/j-jones/photo672173.jpg)
![](https://www.craftsuprint.com/theme/common/images/zero.png)
I printed the sheet onto glossy photo paper, I cut out both parts and then cut a piece of silver card to mat the aperture section on.
I lined up where my topper was going and then die cut a cicle out of the silver card.
I drew around the circle aperature onto the card front and then cut out, I then lined the topper so that if fitted above.
I added the greeting and inner to finish this great baby card.
![](/assets/cup/askcrafter.png)