Lady 10Completed by Gwyneth George

I printed the digi-stamp out onto Super Smooth white cardstock at a smaller size than provided. I then coloured her in using my ProMarkers and cut her out to the line.

I shaped her a bit and stuck her, using glue gel, onto a piece of the same white cardstock, and trimmed this and rounded the corners with a punch before I went around the topper edge with one of the ProMarkers I'd used when colouring the digi-stamp.

I prepared a DL base card by taking three sheets of different coloured backgrounds from kit cup418333_1121 into one of my graphics packages and resizing, trimming and using digital edges, until I was hapy with the design for a DL size card front.

This was printed out onto a sheet of the same cardstock, scored down the side using my Hougie Board, folded in half and then had the excess trimmed off the back.

I then used 2mm deep, double sided, foam tape to attach the topper to the base card I'd created. This is a very elegant lady digi-stamp that's easy to colour in whatever colour scheme you want.