Dinosaur Flip Card KitCompleted by Gwyneth George

The sheet was printed onto super smooth white card and the elements cut out. A slit was made with a craft knife down the inside left and right edge of one frame.

A small ball tool was used to score between each area of the pannel drawing the lines against a ruler.

The pannel was then folded, consertina fasion. Double sided tape was put on the top of the two sides and these were pushed through the two slits made previously in the frame before the tape back was removed and the flaps stuck down.

The pannel was put onto a piece of white card slightly smaller than it to hide the cuts and flaps.

Glue gel was introduced between the consertina panel and the back of the frame using a syringe and the picture was teased into place so that each valley and mountain fold was approx. equidistant.

A white card blank was trimmed to be around half a centimeter longer than the framed pannel was wide. The front of the card was scored along the half way point. The pannel was stuck to the card along the bottom half only. One of the greetings pannels was taken and attached just inside the card inside back.

One of the little example images was stuck on the outside back of the card.