Welcome the Day InsertCompleted by Jaynescards

I reduced the size of the topper and then printed it out twice onto glossy photo paper. I covered a card blank with cup446532_503, using some of the paper remaining I used a punch and punched down one edge.

I stuck this to purple card so only the punched edge was showing and then added a length of ribbon with both ends tucked under the card before I attached this to my card front.

I layered the the topper with foam pads and then using cup122706_5 I cut a out a square again punched the edge and cut the other two corners to match the topper edge.

I added a ribbon bow to complete.