3D Cream Christmas Bell Dangler Embellishment and Card Front
Based on my own original 3D embellishment design, this time as a dangler card. Make up the 3D embellishment as per my tutorial, using just the 7 pieces on the right hand side of the sheet.
Cut out the aperture in the card front.
Use the 8th bell from the centre of the aperture as the backer bell, adding your dangler ribbon or cord before adhering to your 3D embellishment.
Then just attach the dangler 3D embellishment in the aperture of your card. Some decoupage is also included to add that finishing touch. If you like this why don't you go and chack out all my other original 3D embellishment designs. Just click on my name and have a browse.
Photographs from the Community
I cut out the card front and cut the aperture out of that and the front of a card base.
I made the bell as described in the instructions and used some thread to dangle it in the aperture.
I put glitter around the bell and on the centre of the bow. A wonderful card when made up with a lovely design.
