3D Lacy Embellishment and Card Front.Completed by Jean-Marie Penny

This design was printed onto 100gsm decoupage paper. (I actually printed it twice to give me a 4th blue shape).

I chose a 7" (17.2cm) square card and stuck down the base layer centrally with a tape pen. I mounted the 4 gems with 3D glue gel to raise them up.

I then proceeded to teabag fold the 4 purple and 4 blue shapes. I built the 'flower' by joining them together with a wet glue. Once dry I put a purple brad through the centre and with a wet glue attached it all centrally to the lace design.