3D Xmas Tree Snow Globe Shaped Tree DecorationCompleted by Janet Maureen Harvey

The sheet was printed onto 180gsm paper and all elements cut out. 1mm foam tape was used for the layers on both sides.

Decorative red ribbon was trimmed and applied to one of the insides, leaving the ends open to be tied in the future.

An additional piece of double sided sticky tape was applied over the top of this before fixing the two sides together.

Finally, yellow stickles was applied to the star and then, using glitter glue, white glitter was applied to some of the snow flakes and the snow mounds.

A very easy decoration to make and would sell well on table top sales.