Steam Tinker 1 Triple Easel

I printed the two layers of the base onto 220gsm white card and cut these out. I printed the rest of the design onto good quality 255gsm photographic paper and cut out the various elements.

I made the slits on the smaller base where the easel mechanism will fit through and I attached each one to the underside of this smaller base using double sided tape and then attached the base to the larger one using double sided tape.

I assembled each easel topper decoupage using thin foam pads. I then attached each easel topper to the relevant easel using double sided tape. I added the stoppers for each easel to the base using thin foam tape.

I actually used the two smaller elements as the stoppers for the larger element. I finished off by adding the greeting to the base using thin foam pads. This is a gorgeous card and it will fold flat for posting in a 7 x 7 envelope.

loved making this type of card, very simple to cut and assemble Printed onto matt photo paper and backed onto card for the base layer added decoupage and plenty of sentiments to match the envelope also gives a very personal touch to this design