Steam Tinker 3 Triple EaselCompleted by Lisa Bird

To make this wonderful Steampunk easel card I printed all sheets on 220 gsm card.

I then cut out all the elements and followed the instructions that come with this design.

I used foam pads to attach layer two to layer one.

Then I used double sided tape to attach the easel mechanisms in place.

I decoupaged all image elements with foam pads before I attached them to the easel mechanisms.

Next attached the images using wet glue so I could make sure I had then in the correct position.

I then added the easel stoppers using foam pads.

To make the envelope, I used red liner tape for security.

I have added a couple of pictures to show a close up of the layers and then how I put the easel mechanisms.