Blue Vintage Car Fathers Day 3D Rosette 8in Card Kit
This kit is to make a 8in square Ornate Rosette Card front for your 8in folded cards. To use this kit you can make the card in a number of ways.
I use the main picture base, then layer it with the base layer, then add my 4 rosettes and then the frame, i use silicone glue or 3D foam pads, quite deep ones as the card has alot of depth to it. then i finish off with ribbon, I have included a paper ribbon to add if you prefer.
The messge labels i layer these up into 2 if not 3 layers using my foam pads and add this to the centre.
The Main picture image is a guide as to where everything has to go, you will find you have labels and rosettes left over, these would make great gift tags to match your card.
Matching inserts are available to these kits and range from cup nos cup322073_10.
Photographs from the Community
I printed the design on to Crafty Bobs photo paper & then cut out the elements that I required. Using an 8x8 card base I attached the base layer using ds tape. I then attached the next layer using 2mm foam pads.
I created the 4 rosettes, 2 layers each using 1mm foam pads & attached to the card again using 1mm foam pads.
The top layer I attached using 2mm foam pads. I lifted the greeting & attached using 3mm foam pads. I left off the bow at the request of the sender of the card. I made a couple of tags using the left over rosettes.
Although the card is set up for fathers day there are plenty of plain panels so that you could add your own greeting so the card can be used for any occasion.
Also, the colours make it suitable for both male & female recipients & the combinations for this kit don't have to use all the layers.
Its a really versatile design.
