3D Beer Cans Rubber Band Pop Up Box Card
A fabulous card that pops up as soon as it's taken out of it's matching envelope. The rubber band hidden inside the card instantly transforms your lovely design into a box as if by magic!
The card easily folds flat to fit into it's matching envelope and once taken out pops up to form a box including the base which pops into place too. The flaps then fold down to reveal the full beauty of your card which will delight and amaze young and old alike.
There's lots of decoupage in the kit plus greetings and a blank greeting panel for your own sentiment. All the decoupage is separate so you can choose where to put it .... and you can make a different card every time!
The completed Card is approx 5 inch tall x 3 inch wide and 3 inch deep when it's popped open
This Kit contains the 6 sheets required to make this amazing Box Card.
These cards are great for Children's Crafts, they are soo easy to make and they'd love making them too!
There are lots of these to choose from and they would make a great sellers at craft fairs etc.
Full photo by photo instructions are included in the kit.
Photographs from the Community
I printed the card elements onto 200gsm photo paper and the envelope onto 120gsm paper. I scored, cut out, folded and assembled the card as per the very easy instructions.
I then added the rubber band and added all the beer cans either to the bars in the box or on the flaps outside.
I added a sentiment surrounded by the stars and then sat and played with it for ages - these are so much fun and will absolutely wow the recipients.
To finish I assembled the envelope.
Don't be put off by this kit- if you follow the instructions they are soooooo easy - so try one- you will not be disappointed.
Printed on gloss photo card and the envelope on paper.I followed the instructions for scoring,cutting and folding then assembled. there are a lot of elements to choose from and I used most of them. I put the stars and some of the cans on to acetate strips to give height.
and it is certainly a wow factor card for the men.
I printed all elements of the card on to 250gsm card, cut and folded where needed to make the box card base and attached the 3d pop out elements with double sided tape.
I then added the rubber band to complete the pop out mechanism.
Kit comes with a matching envelope which I printed on 120gsm paper which I cut out, scored and folded and glued together.
A very easy card and envelope to make which looks very effective.