Large DL Happy EASTER 3D decoupage
My New, slightly different large DL personalised card design which has a ready to use Large DL card front with easy to cut 3d step by step decoupage topper. Just trim the decoupage layer as much or as little as you wish but making sure it fits around the sentiment at the top of the design.
This design is also available in other coordinating colourways/designs/names etc and together they would make a great set of cards to sell at craft fairs etc.
If you'd like this design personalised with a name of your choice then leave leave me a message via Support Requests above and I'll be happy to see if it's possible to design it for you.
There is an insert available to match this design too.
Photographs from the Community
I printed this sheet on to watercolour cardstock as it suits the style. The base layer was added to a card blank made from yellow hammered cardstock using double sided tape.
I cut the individual letters of the second layer and mounted them using foam pads although, for speed, you could add the second layer as a whole.
The fussy cutting is easy enough though and worth the little bit of extra time. I used some Stickles glitter glue in the centre of the flowers and also on the wings of the butterflies.
The matching inserts finishes the card beautifully.
I printed this sheet on to watercolour cardstock as it suits the style. The base layer was added to a card blank made from yellow hammered cardstock using double sided tape.
I cut the individual letters of the second layer and mounted them using foam pads although, for speed, you could add the second layer as a whole.
The fussy cutting is easy enough though and worth the little bit of extra time. I used some Stickles glitter glue in the centre of the flowers and also on the wings of the butterflies.
The matching inserts finishes the card beautifully.