Firez
The flaming colors in this 3D medallion will capture lots of attention and admiration. All occasion use
Photographs from the Community
![](http://www.pinterest.com/pin/create/button/?url=https://www.craftsuprint.com/card-making/mandala/orange/firez.cfm&media=https://s3.amazonaws.com/finished-cards/gwyneth-george/photo3001.jpg&description=Firez%20on%20Craftsuprint%20created%20by%20GWYNETH GEORGE%20-%20I printed out the sheet on Centura Pearl Snow White card and cut out all the pieces. The main card base used is an 8" square white card. A circle apperature was cut from the card a little above the centre. I split the mandala into two. The largest four layers being mounted one on top of the other with 1mm double sided foam tape, and likewise the smallest three layers. Each manada was mounted ontop of a gold foil circle with an embossed and ripple edge. The backing square provided on the sheet was stuck down inside the card so that it was visible through the apperature. The largest mandala was stuck down centrally through the apperature while the smallest one was stuck down at the bottom right. A greetings plate was placed bottom left.){kind=link}
I printed out the sheet on Centura Pearl Snow White card and cut out all the pieces. The main card base used is an 8" square white card. A circle apperature was cut from the card a little above the centre. I split the mandala into two.
The largest four layers being mounted one on top of the other with 1mm double sided foam tape, and likewise the smallest three layers.
Each manada was mounted ontop of a gold foil circle with an embossed and ripple edge. The backing square provided on the sheet was stuck down inside the card so that it was visible through the apperature.
The largest mandala was stuck down centrally through the apperature while the smallest one was stuck down at the bottom right.
A greetings plate was placed bottom left.
