Third Birthday Waterfall card, tag & envelopeCompleted by Jane Williams

I got a bit confused by this, but that may be my own stupidity, in instructions are really very clear.

I printed the main card on Craftsuprint photo paper, cut it out and folded it.

The "bits", I took their suggestion of printing, then turning the card upside down and printing the "backing" - no need for precise positioning, as it's an overall design.

I scored the folds before cutting, to be sure they were in the right place (again, no need for precise positioning).

Used a double-sided tape dispenser for construction.

I added the optional message on the slider, but be warned, it's a little difficult to slide it back into place, as the top edge of the message catches on the "happy birthday" cross piece. I've added a couple of layer of card "spacer" where the brads go through.

The four red bubbles are mounted on foam pads.

The envelope is very easy to make, and is a good fit. Total is 9cm by 13cm