3D Romantic Hearts Milk Carton Cupcake or Treat Box Mini Kit
**All NEW Template**
2 sheets in the kit
Cupcake Box
Box Canopy
cupcake box inner
3D decoupage
Matching gift Tag
Greetings
A really fun sweet mini milk carton cupcake or treat box. The box closes over the top with a pretty canopy that finishes off the front of the box.
The window area is created with one of my easifold frames so really easy to make and with the addition of a small piece of acetate makes a great viewing window.
The completed Box is approx 7.7 inch tall x 3.5 inch wide and 3.5 inch deep so there's plenty of room inside for a cupcake or treats!!
These could also be used as table or party favours to hold gifts or treats.
This mini Kit contains the 2 sheets required to make this wonderful design that would be great for filled with a cupcake, party treats or they make great favour boxes too.
These are great for Children's Crafts, they are soo easy to make and they'd love making them too!
There are lots of my Mini Milk Cartons to choose from and filled with cupcakes or treats they would make a great sellers at craft fairs etc.
Full photo by photo instructions are included in the kit.
This kit is great for birthday, valentines day, mothers day etc
Photographs from the Community
Great kits for lots of occasions. Using This one for valentines day.
Easy to put together printed out on smooth card,scored cut and folded to add together with DST tape added some acetate on the front and back,with the decoupage at the sides and front finishing with the tag , and a ribbon.filled mine with choc hearts.
I printed the sheets on quality cardstock, scored and cut out all the elements. I used foam pads to decoupage and quick drying, tacky glue to assemble the treat box. This box went together very easily.
I left the muffin out of the box so you could see that there is even a little stand for the inside of the box so that the contents do not roll around.
I threaded a white ribbon through the holes at the top of the box, tied a bow and attached a small red, rhinestone heart.
What a lovely way to present a small treat to a special person.
Printed all elements onto quality cardstock, scored, folded and cut according to instructions. Have just realised my aperture is smaller than in the display photo - I did wonder about the white 'frame' as I did it, but according to the cutting/scoring lines that was how it should be.
I found it a little bit fiddly assembling the box. I used DST as per instructions, but I think a glue stick may have been easier in order to manipulate the edged and base into place.
Overall, happy with the finished result - now to bake a cupcake...