![](https://www.craftsuprint.com/theme/cup/images/multi2.png)
![](/assets/cup/zero.png)
![](https://s3.amazonaws.com/cup-images/annelever/large/cup1135764_1763.jpg)
![Price Promise - You will not find this product cheaper elsewhere!](/assets/cup/bestprice.png)
Meowy Christmas Cat - British Shorthair
This lovely mini kit makes an 8x8 square topper with decoupage, greetings, a blank greetings tile, 2 gift tag toppers and a matching insert.
Photographs from the Community
![](https://s3.amazonaws.com/finished-cards/yana-pritchard/1135764_1639662620716.jpg)
![Goldstar](https://www.craftsuprint.com/assets/cup/goldstar.png)
![](https://www.craftsuprint.com/theme/common/images/zero.png)
Decided to do a quirky design and use a scalloped edge card in landscape mode. I printed off the design on 120gsm card and cut out all the elements.
A sticky ribbon was taped into a parcel effect on the card and each sentiment was glued in each respective corner as decoration.
The cat was layered onto red holographic card to show only two sides, then I used foam pads and layered the Christmas hat and holly.
A piece of holly was attached with foam pads either side of the frame.
A printed insert was DST inside and again I used the smaller frames in two corners. Lovely design for cat lovers.
![](/assets/cup/askcrafter.png)
![](https://s3.amazonaws.com/finished-cards/yana-pritchard/1135764_1639662622381.jpg)
![](https://www.craftsuprint.com/theme/common/images/zero.png)
Decided to do a quirky design and use a scalloped edge card in landscape mode. I printed off the design on 120gsm card and cut out all the elements.
A sticky ribbon was taped into a parcel effect on the card and each sentiment was glued in each respective corner as decoration.
The cat was layered onto red holographic card to show only two sides, then I used foam pads and layered the Christmas hat and holly.
A piece of holly was attached with foam pads either side of the frame.
A printed insert was DST inside and again I used the smaller frames in two corners. Lovely design for cat lovers.
![](/assets/cup/askcrafter.png)
![](https://s3.amazonaws.com/finished-cards/yana-pritchard/1135764_1639662623975.jpg)
![](https://www.craftsuprint.com/theme/common/images/zero.png)
Decided to do a quirky design and use a scalloped edge card in landscape mode. I printed off the design on 120gsm card and cut out all the elements.
A sticky ribbon was taped into a parcel effect on the card and each sentiment was glued in each respective corner as decoration.
The cat was layered onto red holographic card to show only two sides, then I used foam pads and layered the Christmas hat and holly.
A piece of holly was attached with foam pads either side of the frame.
A printed insert was DST inside and again I used the smaller frames in two corners. Lovely design for cat lovers.
![](/assets/cup/askcrafter.png)