Snowman - Christmas Jumper Card Mini Kit

Printed insert onto 200gsm card and all other sheets onto matte coated paper. I used DST to join insert to front and back of card and silicone for the decoupage.

I printed onto matte card. I scored along the back section then fastened front & back together using wet glue. Once dry I attahed the insert then assembled the decoupage using 2mm foam pads.

I printed the back and front on to Crafty Bob's 250gsm matte photo card, and the insert on to 130gsm paper.

I joined the back and front where indicated, then attached the insert. Layered all elements. Added glitter to finish. A sentiment can be added if required.

A very cute design in pretty colours, and a fabulous concept.

I printed these sheets onto glossy photo paper and mounted the main image onto white card stock. I applied all of the decoupage elements with sticky foam dots.

This is a lovely card that anyone would be thrilled to receive.

I placed the main image on cream card with double sided tape and added the decoupage with foam tape. I added peel off strips to top and bottom of card and added a sentiment to bottom right of card to complete.

I printed the design onto good quality white card and cut out all the elements. I inked the edges of all the decoupage elements and, following the very clear instructions, assembled the card using spongy tape.

Finally, I added silver sticker greeting to the bottom of the jumper and went a little crazy with the silver and gold glitter glue, as you do and this very cute card was complete.

I would just love a real jumper like this one but as I live in Australia, it would look a bit strange wearing this in a hot and summery climate!

However, I will send it to my special friend in the US who just loves snowmen!

I printed onto photo paper. Joined the front and back with tape then added the layers using foam pads.