8 x 8 Funky Hearts Mini Kit with Scalloped Corners
A Gorgeous Romantic Funky Heart design
Ready to use Quick card front topper that is a little smaller than 8" x 8" card with scalloped edged corner pyramage layers for the bottom left hand corner ald also (not shown) for the top right hand corner.
Each of the triangle stacker layers are numbered and added in turn to the base layer to create a design that creates a stunning 3d decoupage design. A really easy to make card that produces stunning cards!
The preview shows the stacker made on the bottom left hand corner but also in the kit are the layers for the top right hand corner too. You can use the bottom, or top stackers or a combination of them both, the choice is yours!
In the Kit:- Scalloped edged corner stackers. 3 matching small toppers are also included, these can be used on their own or inside or on the back of your card, and would also make great gift tags too! Or why not include your contact details on the back of one the toppers, and pop in with your finished card ... for future orders!
This design is also available in other coordinating colourways and together they would make a great set of cards to sell at craft fairs etc.
This design is great for Wedding cards but is also suitable for lots of occasions including Anniversary card, Valentine's Day Card, Engagement card, Mothers Day card, Wedding Invitations, Anniversary Invitations, Engagement Invitations, female birthday cards etc
Photographs from the Community
This is a wonderfully easy card to send a loved one for Valentine's Day or simply say 'I love you'. The image for this card shows the complete design used - have a look at cup979488_359 for some variations.
After cutting out all my pieces I used a matching Distress marker on all the edges for some extra definition. I then used foam squares between all my layers. NOTE: if you are making the complete design, as shown here, the lower edge of the top corner overlaps the top edge of the bottom corner. All I did was not take my foam to the very edge of this layer and used wet glue on the part that overlapped.
