Diamante Dragonflies Circle Pyramage TopperCompleted by Gwyneth George

I printed the sheet onto Super Smooth white card and cut all the pieces out. I took a 14.5cm square card and stuck the base image to this. I then used 1mm deep double sided foam tape to stick three of the pyramage layers in place. I finished the card off by using a Sakura clear glaze pen ovr all the diamante.

I only used three of the layers to keep the card profile low to go through the post but an equally good card can be made using all the layers, and even using the main pannel stuck as a topper on a larger card. This is a beutiful card that could be used for many occasions.