All at Sea- Wavy Penny SliderCompleted by Gwyneth George

The sheet was printed onto Super Smooth white card and the pieces cut out. I took a white A5, tent fold, card and trimmed it to just a little larger than the base image.

I stuck the base image in place on this.

I put strips of narrow 3mm deep double sided foam tape just inside the outside edge of the wavy slider piece and attached this in place on the front of the see part of the card.

I took two 10p pieces and stuck them together using a round 3mm deep foam pad and slipped this into the card so that a coin is lying above and below the wavy slider piece.

I then used another foam pad to attach the boat to the top of the coin. A lovely fun card and the boat spins wildly on the sea when the card is tipped from side to side.