Lace Mixed Pansies 5in Rounded Bottom Stacker
I have designed this stacker to give your card fronts a great look that can be built in to fab 3D image.
This is a 5inch square image for card fronts.
Simply use the base layer on your card or project then build up the layers using 3D glue or foam.
I have included a diagram for you to use as a guide.
Photographs from the Community
Design printed on to 120gsm super smooth paper. Covered a pre-shaped scallop eyelet with gold metallic paper, hole punched where the eyelets had been covered. After cutting all the elements out, the base topper was mounted on the card and the other elements were stacked using 3D gel glue.
Ribbon was threaded through all the eyelets and the bow was tied on the inside of the card. To finish off a mini gem to the centre of pansies and a pink gem was added