Metallic Birthday Greeting Quick Card Corner Side Stacker
A Beautiful 5 x 7 card with a lovely Birthday Greeting panal topped Diamond centred flowers and a satin bow. Ready to use card front with an easy to make scallop edge corner side stacker topper. Cut out the triangle stacker pieces and layer on the corner of the main image for a stunning 3d effect. Greetings sentiments are also included on the sheet.
This design will mix, match and coordinate with all my other Flowers with Diamonds downloads too!
There are coordinating Quick Cards with 3D Decoupage, inserts, backing paper, envelopes and vellums to match this design too.
This design is also available in other coordinating colourways and greetings and together they would make a great set of cards to sell at craft fairs etc.
Photographs from the Community
Firstly I printed the sheet onto some good quality decoupage paper & cut all the sections out. I mounted the main piece onto some purple pearlescent card, which I then mounted onto a grey A5 card. I then layered the remaining pieces with Pinflair glue leaving a 1mm space between each layer. As my printer had ?a funny moment? while printing the 1st time & only printed the top half I decided not to waste it, so I cut out & layered the bow also.
I used the ?Birthday Wish? greeting which I layered with Pinflair glue & again leaving a 1mm space. To finish of I added some flower gems that came with a magazine, along the bottom & a pink gem in the centre of each flower. Very easy to make & quite quick ? great for those last minute or forgotten occasions!
