Winter Pub Lace 5inch Triangle Edge Spiral Stacker
I have designed this new design concept to create a spiral rounded edge stacker around a card front.
This is a 5inch x 5inch square card front, and you simply cut out the base image and attach to your card or project flat, then cut out the edges starting at number 1.
Glue your edges using a 3D glue or foam pads, and attach to the base image going around the outside, each edge overlaps the last, this will build up the outside edge into a 3D decoupage effect.
As you glue the edges you are going around the card in a spiral effect.
Photographs from the Community
I cut out 3 red mirri gold panels and used special scissors to give nice edges. I cut out 3 christmas paper panels and used the special scissors and placed inside each red panel.
They were all placed upon the card with foam pads and the spiral stacker was placed in the centre of the card on top of the centre panels.
I added my own sentiment and christmas embellishment. Glittered appropriately.
