Christmas Robin 2 Spiral Edge Stacker
I have designed this to create a spiral edge stacker around a card front. This is a 5inch x 5inch square card front, and you simply cut out the base image and attach
to your card or project flat, then cut out the edges starting at number 1. Glue your edges using a 3D glue or foam pads, and attach to the base image going around the outside, each edge
overlaps the last, this will build up the outside edge into a 3D decoupage effect. As you glue the edges you are going around the card in a spiral effect.
This design matches the card front also available and the duo stacker corners.
Photographs from the Community
I printed the sheet off onto photographic paper and then cut out the base card and the layers. I numbered the layers on the back to help make sure that they were all placed in the correct order.
The base card was mounted onto a variegated orange card which matched the colours on the image. The layers were separated with silicone glue. A nice easy card to make but very effective when finished.