Christmas Stream Snow Square Spiral Rounded Edge Stacker
I have designed this new design concept to create a spiral rounded edge stacker around a card front.
This is a 5inch x 5inch square card front, and you simply cut out the base image and attach to your card or project flat, then cut out the edges starting at number 1.
Glue your edges using a 3D glue or foam pads, and attach to the base image going around the outside, each edge overlaps the last, this will build up the outside edge into a 3D decoupage effect.
As you glue the edges you are going around the card in a spiral effect.
Photographs from the Community
I printed this out on kodak matt finish photo paper. I used lilac card to enhance the colours in the scene, 2mm adhesive foam squares was used for the base and 1mm for the remaining layers.
Finished off with gold and transparent christmas message sticker backed by pink card then cut out and adhered by 2mm foam sqaures.
Finally I used pink and gold trim to complete the card.