Bernese Mountain Dog Portrait 3D DecoupageCompleted by Gwyneth George

I printed the sheet out onto Matte Crafty Bob paper and cut out all the pieces. I prepared a base card by scoreing and folding in half an A4 sheet of white hammered cardstock.

I stuck the base image layer to a sheet of cardstock and trimmed it to leave a small border. I also stuck the pawprints paper ribbon to the same cardstock and the panel with the dog breed name. Each of these was also trimmed to leave a border. I stuck these to the front of my prepared card using finger-lift tape and 1mm deep, double sided, foam tape.

The same tape was used to add the second dog layer and then I shaped the other layers and stuck them on using glue gel.

I've kept this card simple so that it's suitable for a man.