Xmas Santa Quick Card N 3D DecoupageCompleted by Gwyneth George

I printed the sheet onto Matte Crafty Bob paper and cut out all the pieces. I used a quickie glue pen over the fur trim of Santa's outfit and added fine crystal glitter.

I prepared a base card at 1cm larger on each side than the base image using 2 sheets of green Satin Board.

I used fingerlift tape to attach the base image to the card front and then shaped all the Santa layers before sticking them to the card front using glue gel.

I've put the greetings panels to one side for the moment as I don't know which langauge it will be needed in, but if I use it for one of my nephews I'll add a Welsh peel-off greeting before sending.