Tulip Bouquet Lace Card Front Step by Step
I have designed this card front to fit a A5 card based on my original lace design. This is alittle bit more
modren but still with a vintage style and I have made the extra toppers to build a
3D card front for your card or project, these are included on the sheet.
Simply cut out the card front and attach to a blank card, then cut
out the layers and layer up the front using either 3D foam or silicone glue, then add the extras.
Photographs from the Community
The image was printed out onto 180grm everyday glossy photo paper. A piece of silver mirri card was trimmed to just a litle larger than the image and matted to an A5 card with double sided sticky tape.
The main image was matted to the background with double sided sticky tape. 3mm foam pads were used for the layers and for the four bows which I elected to place on the corners of the lace.
I have left the card open until its use is known as it could be used for a number of different occasions.