Sky Card Topper

I printed the sheet off at half size onto 300gsm Super Smooth white cardstock and cut out the pieces. I used a punch to round the corners of the base layer before going round all the layers using a gold Wink of Stella brush pen.

I created a base card of a suitable size out of an A4 sheet of Centura Pearl Snow White cardstock that I scored using my Hougie Board and trimmed.

The base image layer was attached to this using finger-lift tape and the two two top layers were attached using 1mm deep, double sided, foam tape.

I finished off by going over the twinkle at the top of the image with a clear Wink of Stella brush pen and attaching two clear, sticky back, faux gems to the greetings panel.

As I don't know what language the card will be needed in yet I've left the greetings panel blank.