Rocaille seed beads are threaded onto a piece of beading wire. Use the bead caddy spinner. It is assembled with spacer beads and a pendant is attached using round jump rings.
Squeeze the beading wire flat with flatnose pliers at the end so that it can easily go through the eye of the beading needle.
Fill the bead caddy spinner with lots of rocaille seed beads and hold the needle in the opposite direction of the spin.
Turn the lever in the middle clockwise to spin the bead caddy spinner. The needle will automatically fill with beads. Push the beads from the needle onto the wire. If a bead is stuck on the needle or wire, crush it with flatnose pliers.
Attach two oval jump rings; one after the other and then attach to a solid round jump ring.
Put a faceted bead onto a head pin, cut off the excess pin leaving a small piece long enough to form a loop.
Assemble the teardrop faceted bead pendant on the solid ring using an oval ring.
Attach the solid ring onto the rocaille necklace and pull a spacer bead down over the doubled over necklace.
Close the necklace with crimp beads. Put a crimp bead onto each end of the beading wire, followed by a couple of rocaille seed beads. Feed the wire ends through the beads from either side. Pull the ends and squeeze the crimp beads flat using pliers.
