Doily Layer 4

I cut out using pearl white and purple card and mounted over the edge style onto an A5 scalloped edge card.

I layered using thin sticky pads and threaded lilac ribbon through the outer layer, tying at the top into a bow.

I added tiny pearls round the edge and a die-cut butterfly as the main feature. I added a butterfly verse to the centre

I opened the file in my Silhouette Studio software and cut out the intricate layers out of yellow cardstock and the matting layers out of white cardstock. I stuck the intricate layers diretly to the corresponding matting layers. I created a base card from white, linen textured, cardstock, using a paper punch to round the cornes. I went round the outside of the base card and the largerst matting layer with a yellow ProMarker and also used the same ProMarker to put a dotted pattern over the background of the base card. I punched out two different styles of paper flowers out of yellow vellum and some slightly larger flowers out of ice white pearlescent vellum. I attached the largest layer of the doily topper to my base card using 1mm deep, double sided, foam tape and the next layer on top of this using 2mm deep tape. I used glue gel to put smaller yellow flowers on top of the slightly larger white ones and then stuck these in the centre of the doily topper, and finished off by putting four of the other type of punched yellow flowers one in each corner.

This is a lovely design that cut perfectly from the 250gsm cardstock I used and could be used on cards for many occasions.