The Filigree part of this design needs careful removal from carrier mat, unless you are using Vinyl.
This design would make a nice fancy label for your kitchen storage jars cut from vinyl, or a decorative vinyl frame for a card front...This design could also be cut from adhesive Pearlescent paper or vellum..
Filigree Frames & Mats
Photographs from the Community
I printed some backgrounds out. I know that the pink one is from cup349843_1749 and I think that the two lighter ones are from cup355544_1749 only printed when the ink was running out so they are lighter than they should be.
I cut the layers of my chosen frame and mat out using my digital cutting machine from the printed backgrounds.
I also cut out some little flowers from the same backgrounds at the same time. I used quick grab wet glue to stick the top layer to the next layer, and then used 2mm deep, double sided, foam tape to stick the frame to the back mat.
This was then attached to the front of my card using 1mm deep double sided foam tape. I sued glue gel to double up the flower layers and attach them to the card, which is a 6" square, scalloped edge, card, and finished off by putting small faux sticky back pearls in the centre of each flower.
The greeting is "Diolch" - which is Welsh for "Thank You".
![](http://www.pinterest.com/pin/create/button/?url=https://www.craftsuprint.com/cutting-files/frames-mats-doilies/various/filigree-frames-mats-m.cfm&media=https://s3.amazonaws.com/finished-cards/gwyneth-george/photo666230.jpg&description=Filigree Frames Mats%20on%20Craftsuprint%20created%20by%20GWYNETH GEORGE%20-%20I printed some backgrounds out. I know that the pink one is from cup349843_1749 and I think that the two lighter ones are from cup355544_1749 only printed when the ink was running out so they are lighter than they should be. I cut the layers of my chosen frame and mat out using my digital cutting machine from the printed backgrounds. I also cut out some little flowers from the same backgrounds at the same time. I used quick grab wet glue to stick the top layer to the next layer, and then used 2mm deep, double sided, foam tape to stick the frame to the back mat. This was then attached to the front of my card using 1mm deep double sided foam tape. I sued glue gel to double up the flower layers and attach them to the card, which is a 6" square, scalloped edge, card, and finished off by putting small faux sticky back pearls in the centre of each flower. The greeting is "Diolch" - which is Welsh for "Thank You".){kind=link}