Let It Snow Topper

I cut the main elements in white pearlescent card, omitting the bottom layer as I wanted more of the base card to show.

I cut the snowflakes in blue card and glittered them.

Using foam tape I attached the bottom layer in use to the base card of blue pearlescent card, sealing it all the way round so that the tiny glass beads and fake snow would not fall out which I put on next.

I used dst all the way round and sealed over this layer with clear acetate. Next, using foam pads I added the other layers, and the snowflake. I topped it off with some gems and little flat back pearls to create what I think is a fun shaker card.

I cut all the main elements using pearlescent card in white. However I did not use the bottom layer as I wanted more of the base card to show.

I used foam tape to secure the first layer to the base card ensuring that it was sealed all the way round so the tiny beads and fake snow would not leak.

Once I had dropped some of this onto the card I then sealed it in using a piece of clear acetate cut to size.

I then finished adding the layers and the snow flake cut from blue card and glittered.

I also added a few gems and pearls to finish off this pretty shaker card.