Card Topper Kit 3Completed by Gwyneth George

I took various elements from this kit into one of my graphics packages and moved about, layered, and re-sized until I had panels I liked as a decorative card front, topper layer, inside/base layer, and various elements to decoupage. I then printed the A4 sheet out onto 300gsm Super Smooth white cardstock. I took an A4 sheet of hammered white cardstock, scored and folded it in half. I put the topper layer on this, overlapping the folded edge by a bit, and drew around this. I cut out the shaped card and then scored it across the half way line of the front. My card front layer was attached to the bottom half of this using fingerlift tape. My insert/bottom panel was also stuck inside using the same tape. I used 2mm deep, double sided, foam tape to attach the topper layer and the bow which I used as a stopper. I then used glue gel to attach the flower and leaf layers.

This is a lovely little kit with lots of elements to build up lots of different styles and shapes of cards.