Needlepoint is used to make designs that can be finished as key chains, belts, pillows, bookmarks, stockings, belt buckles, or almost anything. Sew a finished design onto a canvas bag or frame it and put it up on the wall. It is an enjoyable hobby that can be taken anywhere and needs the use of only a few basic types of stitches.
Steps
-
Learn the different types of stitches and when to use them:
- When reading all the stitch guide graphics in this wikiHow, you bring the needle up to the "good" side of the canvas on the odd numbers, and push the needle down to the "wrong" side of the canvas on all the even numbers.
-
-
-
- Backstitch: This stitch is used for stitching a very small piece or outlining an area using thread.
-
-
- Put all of your materials in a zip lock bag. Keep your excess yarn organized too!
-
- Trace the outline of the canvas on thick paper or cardboard. This outline will be used later to "block" the canvas once stitching is completed.
- Attach the canvas to a needlepoint frame, if you are using one.
- Decide where you want to stitch first. It is generally best to select the smallest amount of color or most detailed area first. Then stitch the larger areas that surround the more detailed bits.
-
-
-
-
-
-
- Repeat, stitching in diagonal or horizontal lines across the canvas, until you have finished the area of color.
-
Continue stitching until it becomes difficult to pull the string through because it is too short. If the string becomes mussed, this is another good sign to stop. On the "wrong" side push the needle through three or four stitches and pull the string through. It isn't completely necessary, but it is generally a good idea to snip off the excess string.
- Finish stitching the project. Be patient and take breaks if you become bored with your project. Try changing the area you're stitching.
- Stitch the edges with the blanket stitch if you wish to do so. Belts and keychains are almost always finished in this way, but other projects such as pillows are finished differently around the edges.
- Block the canvas if it has become distorted. Remove the canvas from the frame (if you used some), dampen it (don't saturate it) with water, lay it (good side down) on the outline you drew before you started stitching (with a surface you can nail underneath) and stretch it out to its original shape. Pin it down with tacks or nails at one-inch (2.5 cm) intervals all the way around and allow to dry before removing. Repeat as needed.[1]
- Take the project to a needlepoint shop to finish (e.g. framing or making it into a pillow). Crafty individuals may be able to finish simple projects themselves.
-
Enjoy and admire your finished project.
Tips
- Masking tape can be difficult to pull off in hot or humid weather and may permanently mark the canvas if it stays on too long. You can avoid this by placing masking tape a good inch away from the design. Artist's tape (buy at art stores) is a non-staining alternative.
- You will get the best results if you start in the top right corner and use the Basket Weave stitch on large areas.
- When you have patches of the same color that are close to each other (within a half inch), you can carry the thread across to the adjacent area on the "wrong" side of the canvas. If the color areas are farther than about one half inch apart, you will need to snip the string off and start again.
- You can do needle point in any order you like; if you're bored of one color or area, secure the string and start somewhere else! It is best though to start with the lightest colors and go to the darkest.
- Your thread will probably become twisted as you stitch. Every few stitches let the needle dangle so it can unwind.
- Needlepoint stitches are usually slanted up and to the right. This isn't about types of stitches, just whether they point to the left of right. However, this doesn't really affect the needlepoint- it is just the more commonly used direction.
- If your design calls for a single stitch of a color (such as an eye of an animal), do that stitch first, tie a knot on the "wrong" side of the canvas and then stitch around it and secure the stitch.
- The thickness of your thread can also distort the canvas. If the thread is too thick, the holes around a stitch will be distorted. If it is too thin, you will be able to see through the stitched canvas.
- Pay attention to the tension of your stitches. If you make them too tight it will cause the canvas to bend weirdly. If you make them to loose they will stick up and be bigger than the rest. Aim for uniformity, but don't stress about it too much.
- You should never have any knots in canvas or tapestry work. Make a knot in the end of your thread, go down through the canvas and up at the starting point leaving a knot on the front on your line of stitching. This is called a waste knot.Stitch towards the knot covering the thread on the back. When nearly to the knot cut it off and continue working.
Warnings
- Needlepoint needles are not sharp enough to draw blood, but avoid poking yourself, as it is painful.
- Work on projects in an area with good lighting. Do not try to work with bad lighting and strain your eyes.
- Sometimes a stitch will be evenly painted as two different colors. You will have to use your best judgment and look at the design. If there are other identical shapes in the pattern, use those as a reference. If you decide you don't like it after you have stitched it you can always pick it out and start over.
- Be careful not to wait too long to finish your project if it is going to be made into a belt or similar item. You could grow (or shrink) and then it would be the wrong size!
- It is much better to hem or zigzag-stitch the edges of the canvas than to use masking tape. The tape will leave residue behind when you remove it (particularly if it takes you a while to finish) and may permanently stain the canvas or pull out threads when you remove it.
Things You'll Need
- Needlepoint canvas (size 14)
- Needles (size 20 or 22)
- Embroidery floss or yarn
- Scissors
- Masking tape
- Ziploc bag
- Tote or canvas bag (optional)